13. Remove the canopy cover from the bottom of the
canopy (Fig. 13).
Helpful Hint: The downrod, hanging ball, and canopy
cover are not used in this type of installation.
14. Align the canopy with the closemount screw holes
in the top of the motor housing. Secure the canopy
to the top of the motor housing by installing three
closemount screws and spring washers into the top
of the motor housing (Fig. 14).
Closemount Screw
15. Raise the fan and place the canopy on the
mounting bracket hook for wiring (Fig. 15).
CLOSEMOUNT INSTRUCTIONS
Spring Washer
Fig. 13
Fig. 14
Spring
Washer
Fig. 15
10
Canopy
Cover
Closemount
Screws
Canopy
Canopy
Hook