Cleaning The Reading Window - Panasonic FZ-M1 Series Operating Instructions - Reference Manual

<only when [Concealed Mode] is set [Enabled]>
n
Set [Rotation Lock Button] to [Barcode Reader Trigger] in the [Tablet Button Configuration] of [Main] menu of the Setup Utility.
If an error message appears and nothing is displayed, restart this utility.
n
To disable the automatic rotation of the screen when reading the barcode, press the
n
When the computer has resumed from sleep and hibernation, an error may appear and the connection with this utility may be lost. If
n
this occurs, perform step 1.
To Correctly Read a Barcode with This Computer, Observe the Following
The reading angle is important factor.
Perform reading at the angle indicated in the figure. We recommend you to set at approximately 2° to 3° angle from the perpendicular position.
Hold the reader farther away when reading a larger barcode, and closer in when reading a smaller barcode.
Perform reading so that the entire symbol falls within the center of the red Barcode Reader light. The reader can still read a barcode
even if the barcode is not in the center of the red Barcode Reader light.
However, if a part of the barcode lies outside the Barcode Reader light, the barcode cannot be read. Make sure the entire barcode is
inside the Barcode Reader light.
Correct
C. Barcode Reader Light

Cleaning the Reading Window

If the reading window is dirty, gently wipe the reading window with a cloth or a cotton swab moistened with water. Do not allow materials that can easily
scratch the reading window to touch the window, such as sandpaper or metal object.
For parts other than the reading window, please read
Decode Capabilities
Following symbologies are supported as the factory default.
Codabar, Code 128, EAN 128, Code 39, DataMatrix, Interleaved 2 of 5, PDF417, QR Code, RSS-14, RSS Limited, RSS Expanded, UPC-A,
UPC-E, EAN-8, EAN-13
Following symbologies also can be used by specifying them with Barcode Configuration Utility.
Incorrect
"Handling and Maintenance".
- 80 -
Rotation Lock Button .