Panasonic FZ-M1 Series Operating Instructions - Reference Manual page 117

Connecting Peripherals
An error occurs while installing the driver.
A peripheral device does not work.
The connected mouse does not work.
You do not know the address map for IRQ,
I/O port address, etc.
<Only for model with Serial Port>
The device connected to the serial port
does not work.
<Only for model with dedicated GPS / GPS
on wireless WAN>
GPS does not work.
When you install a driver of card or peripheral device, make sure that the driver is compatible
with the operating system. If it is not compatible, malfunction may occur. For information about
the driver, contact the manufacturer of the peripheral device.
Install the driver.
Contact the manufacturer of the device.
When operation resumes from sleep or hibernation, devices such as an external mouse and
cards may not function properly. In this case, restart the computer or reinitialize the device.
When or is displayed in the Device Manager, remove and insert the device. If the
problem persists, restart the computer.
When you set [USB Port] to [Disabled] in the [Advanced] menu of the Setup Utility, USB ports of
cradle are also disabled.
The settings of USB ports can be changed separately for the computer and the cradle
(optional). In the [Advanced] menu of the Setup Utility, check both
Port] settings.
The computer may not recognize the connection/removal of some devices, or may not operate
normally with some devices.
1. Touch and hold
ager].
2. Select the device, and remove the check mark for [Allow the computer to turn off this
device to save power] in [Power Management]. (This item may be unavailable for
some types of devices.)
In the case that a USB device does not work, remove the USB device and connect it again.
Check the mouse connection.
Install the driver compatible with the connected mouse.
You can check with the following procedure.
1. Touch and hold
ager].
2. Touch [View] - [Resources by type].
Check the connection.
The device driver may not work. Refer to the instruction manual of the device.
Set [Serial Port] to [Auto] in the sub-menu of [Serial Port Settings] in the [Advanced] menu of the
Setup Utility.
You can check the GPS status. (
Set airplane mode to OFF.
Check the airplane mode setting.
If a USB 3.0 compatible device is used, GPS information may not be correctly received. In this
case, do any of the following.
<Only for model with USB 2.0 port>
Connect the USB device to the USB 2.0 port.
Use an extension cable (separately sold) compatible with USB 2.0.
If an external antenna for GPS can be used, use the external antenna, and keep some
distance between the external antenna and the USB device.
- 117 -
(Start) at the bottom left corner, and then touch [Device Man-
(Start) at the bottom left corner, and then touch [Device Man-
GPS)
[USB Port] and [Cradle USB