Panasonic FZ-M1 Series Operating Instructions - Reference Manual page 113

Sleep / Hibernation / Resume
Cannot enter sleep or hibernation.
Cannot enter sleep or hibernation auto-
matically.
The computer does not resume.
[Enter Password] does not appear when
resuming from sleep/hibernation.
Display
No display.
Remove USB devices temporarily. If the problem persists, restart the computer.
It may take 1 or 2 minutes to enter sleep or hibernation.
The computer does not enter sleep or hibernation immediately after resuming. Wait approx-
imately 1 minute.
Disconnect peripheral devices.
If you connect to a network using wireless LAN function, select the profile and connect to the
access point ( Disabling/Enabling Wireless
If you do not use wireless LAN function, turn off wireless LAN function (
Wireless Communication).
Make sure that you are not using any software that regularly accesses the flash memory.
If you press and hold the power switch
turned off forcibly and the computer will not resume. In this case, all unsaved data will be lost.
You disconnected the AC adaptor and the battery pack while the computer was in sleep. If the
computer's power supply is disconnected in sleep, unsaved data will be lost and the computer
will not resume.
The battery is exhausted. Sleep and hibernation consumes some power.
An error may occur when the computer automatically enters the sleep or hibernation mode
while the screensaver is active. In this case, turn off the screensaver or change the pattern of
the screensaver.
Select [Enabled] in [Password On Resume] in the [Security] menu of the Setup Utility (
Setup Utility).
The Windows password can be used instead of the password set in the Setup Utility.
Add a password, and set up the following.
1. Touch (Settings) - [Accounts].
2. Touch [Sign-in options], and touch [Add] under "Password".
3. Create a password.
4. Touch .[Next].
5. Select [When PC wakes up from sleep] under "Require sign-in".
The display is turned off by the power-saving function.
Touch the screen.
The computer entered sleep or hibernation by the power-saving function. To resume, press the
power switch .
When using an external display,
Check the cable connection.
Turn on the display.
Check the settings of external display.
- 113 -
Communication).
Disabling/Enabling
for 4 seconds or longer, the power will be