Safety Statements - HP Cloudline CL2100 G3 806R User And Maintenance Manual

ВНИМАНИЕ:
Внимание: Этот сервер предназначен для использования на системе распределения питания,
максимальное напряжение которого составляет 240 V при любых условиях неисправности
системы

Safety Statements

READ THIS IMPORTANT SAFETY INFORMATION SECTION. RETURN THIS MANUAL FOR REFERENCE.
READ THIS SECTION BEFORE SERVICING.
CAUTION:
Laser Drive Equipment
The optical transceiver module in this server is a laser Class 1 product.
Ambient Operation
This equipment cannot be operated above an ambient operation temperature of 40 degrees
centigrade.
Equipment Location
This equipment can only be accessed by SERVICE PERSONNEL or by USERS who have been
instructed about the reasons for the restrictions applied to the location. Access is through the use
of a TOOL or lock and key, or other means of security, and is controlled by the authority
responsible for the location.
DANGER
Не помещайте никаких предметов сверху устройств монтируемых в стойку.
CAUTION: The server system is designed to work with single-phase power with a
grounded neutral conductor. Do not connect the server to any other type of power
system to reduce the risk of electric shock.
WARNING: This server is suitable for use on an IT power distribution system whose
maximum phase-to-phase voltage is 240 V under any distribution fault condition.
Electrical current from power, telephone, and communication cables is hazardous. To
avoid a shock hazard:

Do not connect or disconnect any cables or perform installation, maintenance, or
reconfiguration of this product during an electrical storm.

Connect all power cords to a properly wired and grounded electrical outlet.

Connect to properly wired outlets any equipment that will be attached to this product.

When possible, use one hand only to connect or disconnect signal cables.

Never turn on any equipment when there is evidence of fire, water, or structural damage.

Disconnect the attached power cords, telecommunications systems, networks, and modems
before you open the device covers, unless instructed otherwise in the installation and
configuration procedures.

Connect and disconnect cables as described in the following table when installing, moving,
or opening covers on this product or attached devices.
To Connect:
1 Turn everything OFF.
2 First, attach all cables to devices.
3 Attach signal cables to connectors.
4 Attach power cords to outlet.
5 Turn device ON.
To Disconnect:
1 Turn everything OFF.
2 First, remove power cords from outlet.
3 Remove signal cables from
connectors.
4 Remove all cables from devices.
Warnungen & Sicherheit/
Предупреждения и безопасность 123
Warnings & Safety/