Toshiba MMY-MUP0801HT8P-TR Service Manual page 77

<RBC-ASCU11*>
1
Push and hold menu button and [
• After a while, the display flashes as shown in the figure. "ALL" is displayed as indoor unit numbers during
initial communication immediately after the power has been turned on.
2
Each time [ ] [
change cyclically. Select the indoor unit to change settings for.
• The fan of the selected indoor unit runs . The indoor unit can be confirmed for which to change settings.
3
Push OFF timer button to confirm the selected indoor unit.
4
Push the menu button to make Code No. [ 04 ] flash. Change Code No. [ 04 ] with [
[ ] setting button.
5
Push the menu button to make Set data [ 0001 ] flash. Change Set data [ 0001 ] with [
[ ] setting button.
Priority set 0001 No priority set 0000
6
Push OFF timer button to complete the set up.
• To change other settings of the selected indoor unit, repeat from Procedure
7
When all the settings have been completed, push ON/OFF button to finish the settings.
(Return to the normal mode)
" " flashes and then the display content disappears and the air conditioner enters the normal stop
SETTING
mode. (The remote controller is unavailable while "
• To change settings of another indoor unit, repeat from Procedure
3,6
4,5 1
] setting button simultaneously for 10 seconds or more.
Indoor unit No.
] setting button is pushed, indoor unit numbers in the group control
Set data
2,4,5
7
Code No.
" is flashing.)
SETTING
1
.
- 77 -
]
4
.
]