Advertisement
Frame Assembly
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
• Unless otherwise noted, attach frame parts using Bolts (43) and Nuts (52) provided.
Tighten nuts 1/4 turn past finger tight; do not overtighten.
• Bolt heads will fit into slots on back of studs to hold bolts in place during assembly.
• Lay out all parts by number prior to assembly.
• Use an assistant or appropriate support (sold separately) to keep partially assembled parts
upright during assembly. Use two assistants to assemble Crown pieces to the frame.
• Assemble on a clear, calm day. Wind will damage the Greenhouse and make assembly difficult.
Assembling the Corners, Edges, and Rear Frame
36
36
8 8
21
21
1 1
16
16
34
34
1. Attach Corner Posts (1) to Floor Plates (16,
17, 34). Attach Corner Post to outside of each
corner, with the end with two holes at top.
Page 8
4 4
13
13
21
21
1 1
9 9
4 4
8 8
21
21
13
13
21
21
1 1
16
16
9 9
16
16
Figure G: Outer Frame and Rear Frame
For technical questions, please call 1-888-866-5797.
35
35
5 5
13
13
36
36
3 3
36
36
1 1
1 1
34
34
2. Drill three pilot holes 1-1/2" through each
Floor Plate and into underlying wood sill or
base. Do not drill into hardware used earlier.
Secure Floor Plates to sill or base using
1-1/2" long wood screws (sold separately).
35
35
3 3
2 2
1 1
34
34
17
17
Item 47712
2 2
Advertisement
