Advertisement
Assembling the Front Frame
14
14
19
19
19
19
39
39
3 3
19
19
23
23
3 3
13
13
25
25
1 1
1. Attach Right and Left Doorway Studs (6,7) to
outside of Front Floor Plate (17) using Bolts (42)
and outside of Front Right and Left Crown
Beams (2,3) using Bolts (43) and Nuts (52).
Cutoff corners on Studs should be at top and
face away from center of greenhouse.
2. Attach Front Horizontal Brace (23) to inside
of Corner Posts (1) and Right and Left
Doorway Studs (6,7) in locations shown
above using Bolts (42) and Nuts (52).
3. Attach Front Diagonal Braces (25) to inside
of Right and Left Doorway Studs (6,7), Front
Floor Plate (17), and Corner Gussets (13) with
angle facing away from Corner Gussets and
Doorway Studs using Bolts (43 - t op), existing
Bolts (42 - b ottom) and Nuts (52). Front Diagonal
Braces and Right and Left Doorway Studs will
share Bolt (42) and Nut (52) at bottom connection.
Item 47712
19
19
13
13
25
25
23
23
1 1
Figure J: Front Frame
For technical questions, please call 1-888-866-5797.
8A
8A
14
14
12
12
3 3
23
23
23
23
6 6
23
23
7 7
25
25
17
17
4. Remove protective film from both
sides of Panel (8A).
Note: Ensure window side covered in white
film is facing outwards when installed.
5. Slide Panel (8A) into grooves in Front Right and Left
Crown Beams (2,3). While holding Panel in place,
Slide groove of Top Doorway Beam (12) onto bottom
of Panel and attach Top Doorway Beam between
Front Right and Left Crown Beams (2,3) with nicked
corners facing up and two remaining holes facing
outside to allow Door Rail (14) to be attached.
6. Attach Door Slide Support (19) to Front Left Crown
Beam (3) using Long Door Support Bolt (41)
and Nut (52), with Door Support Spacer (39)
between Support and Crown Beam.
7. Place three Bolts (43) in Slots in back of Door
Rail (14). Attach Rail to Top Doorway Beam (12)
and free end of Door Slide Support (19) with
rounded side up and secure with Nuts (52).
2,3
2,3
8A
8A
12
12
2 2
25
25
7 7
13
13
23
23
25
25
7 7
1 1
Page 11
1 1
17
17
Advertisement
