Advertisement
Assemble one Panel at a time and secure with Panel Clips before proceeding.
Install all Side, Front, and Rear Panels before installing Roof Panels.
Note: Remove protective film from both sides of
Panels as they are installed. After removing protective
film from Door Center Panel (7A), attach warning
label so it is readable from outside of greenhouse
after panel is installed. Install Door Center Panel.
Note: Ensure window side covered in white
film is facing outwards when installed.
1. Assemble Door Panels (7A,9A) into openings
of door and secure in place with Panel
Clips (29), Bolts (43), and Nuts (52).
2. Place each Side Panel (1A,3A,6A) in its proper
location on front, sides, and rear of greenhouse
frame, confirming Panels fit into channels on corner
posts, studs, etc. Secure in place with Panel
Clips (29), Bolts (43), and Nuts (52) (See Figure N.)
Use and Maintenance
1. BEFORE EACH USE, inspect general condition of
Greenhouse. Check for loose screws, misalignment
or binding of moving parts, cracked or broken
parts, and any other condition that may affect safe
operation of Greenhouse. If a problem occurs
with the Greenhouse, have it corrected
before further use.
Do not use damaged equipment.
Record Product's Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Replacement parts may be available for this item.
Visit harborfreight.com/parts for a list of in stock parts. Reference UPC 1 93175497147.
Item 47712
For technical questions, please call 1-888-866-5797.
3. AFTER all Side Panels are installed and
secured, install Roof Panels (2A,4A):
a. Slide Roof Panels (2A,4A) into channels of
Roof Studs (11) and Crown Beams (2,3,4,5)
and into channel of Crown (35) or
Window Support Beams (15).
b. Slide End Caps (18) onto Roof Panels (2A,4A)
in-between Roof Studs (11) and Crown
Beams (2,3,4,5), and secure them and Roof
Panels in place with Side Fixtures (37), Angle
Fixtures (38) and Screws (44) (See Figure N.)
Note: Thread Screws (44) into circular portion of
Roof Studs (11) and Crown Beams (2,3,4,5).
4. After Panels have been installed, Insert a
Screw (45) through Panel into Horizontal
Braces (22) for each (See Figure N.)
2. TO CLEAN: Wipe with a damp cloth, using a mild
detergent.
Do not use cleaners that are combustible,
corrosive, or not compatible with aluminum.
3. WHEN STORING: Keep Greenhouse
in a box in a clean, dry location.
Page 17
Advertisement
