Cisco 7800 Series User Manual page 76

CISCO 7800 SERIES
Note Your Cisco IP Phone administrator must enable hookswitch calling for the
Y-Cable to work.
Figure 10: Multibase LEDs
The following table describes the multibase.
Table 14: Multibase LEDs
Number Name
1 Battery Status LED
2 Call Status LEDs
3 Mute Status LED
4 Bluetooth Status LED
GoMomentum.com
Description
Indicates the headset battery charge:
Also indicates when the headset firmware is being upgraded
and when the base is not paired with a headset.
Alerts you to the call state:
• Active Source—Steady white
• Incoming call—Blinking green
• Active call—Steady green
• Call on an inactive source—Pulse green
Alerts you when your headset is muted.
Alerts you to the Bluetooth status:
• Paired with a call source—Steady white
• Pairing mode—Blinking white
• Searching for a call source—Pulse white
• Bluetooth is Off—LED is blank
66
USER GUIDE
888.538.3960