Cisco 7800 Series User Manual page 74

CISCO 7800 SERIES
The following table describes the Cisco Headset 561 and 562 Headset buttons.
Table 12: Cisco Headset 561 and 562 Headset Buttons
Number Name
1 Power and Call button
2 Mute button
3 Volume button
4 LED
GoMomentum.com
Description
Use to power the headset on and off.
Press and hold for 4 seconds to power on and off the headset.
Incoming and active call management depends upon if you have one call
or multiple calls.
One call:
• Press once to answer incoming calls.
• Press once to put an active call on hold. Press again to retrieve a call
from hold.
• Press twice to reject an incoming call.
• Press and hold to end an active call.
Multiple calls:
• Press once to put an active call on hold, and to answer a second
incoming call.
• Press once to put a current call on hold. Press again to resume a call,
or press and hold for 2 seconds to end the current call and to resume
a held call.
• Press and hold to end an active call, and to answer another incoming
call.
• Press twice to stay on a current call, and to reject a second incoming
call.
Toggle the microphone on and off. The Mute
when Mute on the headset is enabled.
Adjust the volume on your headset.
Shows the headset status:
• Blinking red—Incoming call.
• Steady red—Active call.
• Blinking white—Firmware upgrade is in progress.
64
USER GUIDE
on the phone lits up
888.538.3960