Table of Contents
Advertisement
154 Driving and parking
Always make sure that nobody is within
#
the range of the garage door's move-
ment.
Only operate the following doors using the garage
door opener:
Doors with a safety stop and reversing func-
R
tion
Doors which conform to the current U.S.
R
safety standards
Before programming the garage door opener, park
the vehicle outside the garage. Make sure that the
vehicle is switched on but not started.
Requirements
The vehicle has been parked outside the
R
garage or outside the range of movement of
the door.
The vehicle is switched on.
R
The vehicle has not been started.
R
%
The garage door opener function is always
available when the vehicle is switched on.
Check if the transmitter frequency of the
#
remote control has the frequency range of
280 to 868 MHz.
Radio equipment approval number:
NZLMUAHL5 (USA)
R
4112A-MUAHL5 (Canada)
R
Press and hold button 1,
2
or
#
wish to program.
Indicator lamp
4
flashes yellow.
%
It can take up to 20 seconds before the indi-
cator lamp flashes yellow.
Release the previously pressed button.
#
Indicator lamp
4
continues to flash yellow.
Point remote control
5
from a distance of
#
0.4 in (1 cm) to 3 in (8 cm) towards button
1,
2
or 3.
Press and hold button
6
of remote control
#
5
until one of the following signals appears:
Indicator lamp
4
lights up green continu-
R
ously. Programming is complete.
Indicator lamp
4
flashes green. Program-
R
ming was successful. Additionally, syn-
chronization of the rolling code with the
door system must be carried out.
If indicator lamp
4
does not light up or flash
#
green: repeat the procedure.
Release all of the buttons.
#
3
that you
Advertisement
Table of Contents
