Table of Contents
Advertisement
Compact Flash Master/Slave
Select
Two Compact Flash Master (Primary)/
Slave (Secondary) Select Jumpers are
located at JCF1/JCF2. Close these
jumpers to enable Compact Flash
Cards. For a Compact Flash Card or
the Compact Flash Jumper to work
properly, you will need to connect a
power cable to its corresponding power
connector fi rst. Refer to the board
layout below for the location.
LAN1
LAN2
SIM1U IPMI
PCI-X 100MHz ZCR
PCI-X 133MHz
Chan. A SCSI
SBX-E2 X4
SBX-E1 X8
BIOS
B
A
2-25
Chapter 2: Installation
Compact Flash Card Master/
Slave Select
Jumper Defi nition
Open
Slave (Secondary)
Closed
Master (Primary)
A. JCF1: Compact Flash
FP CTRL
Master/Slave Select
B. JCF2: Compact Flash
Master/Slave Select
CPU1
CPU2
Advertisement
Table of Contents
