3rd PWR Supply PWR Fault
Detect (J3P)
The system can notify you in the event
of a power supply failure. This feature is
available when three power supply units
are installed in the chassis with one act-
ing as a backup. If you only have one
or two power supply units installed, you
should disable this (the default setting)
with J3P to prevent false alarms.
VGA Enable/Disable
JPG1 allows you to enable or disable the
VGA port. The default position is on pins
1 and 2 to enable VGA. See the table
on the right for jumper settings.
GLAN1
PCI-X 100MHz ZCR
PCI-X 133MHz
GLAN2
SAS
B
CTRLR
Jumper Setting
Closed
Open
A
PWR
4-pin
8-pin PWR
SMB
JPWF
PWR
SXB-
SXB-
SXB-
2-27
Chapter 2: Installation
3rd PWR Supply PWR Fault
Jumper Settings
Defi nition
Enabled
Disabled (*Default)
VGA Enable/Disable
Jumper Settings (JPG1)
Both Jumpers
Defi nition
*Pins 1-2
Enabled
Pins 2-3
Disabled
A. 3rd PWR Fail
B. VGA Enabled
JOH1