3Rd Pwr Supply Pwr Fault; Sas Controller Enable - Supermicro X7DA3 Plus User Manual

X7DA3+ User's Manual

3rd PWR Supply PWR Fault

Detect (J3P)
The system can notify you in the event
of a power supply failure. This feature is
available when three power supply units
are installed in the chassis with one act-
ing as a backup. If you only have one
or two power supply units installed, you
should disable this (the default setting)
with J3P to prevent false alarms.

SAS Controller Enable/

Disable
JPS1 enables or disables the AIC
9140W Adaptec SAS Controller on the
motherboard. See the table on the right
for jumper settings. The default setting
is enabled.
JPW2
LAN1/2
CD1
Audio
HD CTRL
Audio
SIM LP IPMI
PCI-Exp x16
PCI-33MHz
A
CPU
PSF
J17
Fan 1
JPW1
J3P
JAR
SAS
Controller
2-26
3rd PWR Supply PWR Fault
Jumper Settings
Jumper Setting Defi nition
Closed Enabled
Open Disabled (Default)
SAS Controller Enable
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled
(default)
Pins 2-3 Disabled
8-pin PWR
JPW3
A. 3rd PWR Fail
B. SAS Enable
B