Pdsmi Quick Reference - Supermicro PDSMi User Manual

Jumper
JBT1
2 2
JI C1/JI C2
JP3
JPF
JPG1
JPL1/JPL2
Connector
24-PIn ATX (JPW1)
8-Pin PWR (JPW2)
COM1(J31), COM2
DIMM#1A,#2A,#1B,#2B
Fans 1-6
FP Control (JF1)
Floppy Connector (J27)
IDE-Primary (J3)
IDE-Compact Flash (J4)
IPMI
J9
JL1
JLED
KB/MS(J28)
LAN1/LAN2 (JLAN1/2)
Printer (J30)
SATA 0-3 (I-SATA 0-3)
Slot 1
Slot 6+SXB-E1
Speaker
USB1/2 (J15)
USB3/4 (J45),USB5/6 (J46) Front Panel Accessible USB headers 3,4,5,6
VGA (JG1)
WOL(WOL)
WOR(JWOR)
LED Indicator
LE 1
LE3/LE4
*Note 1: J4 (the white slot) is for Compact Flash Card only. Do not use it for other
devices. If J4 is populated with a Compact Flash Card, J3 (the blue slot) can support
a single device. For JP3 to work properly, you need to connect the Compact Flash
Card PWR Cable to JWF1 fi rst. *Note 2: See Pg.2-7 for pin defi nitions

PDSMi Quick Reference

Description
CMOS Clear
2
I C (SMB) Bus to PCI slots
Compact Flash Master/Slave Select (Closed: Master)
Power Force-On
VGA Enable
Giga-bit LAN 1/2 Enable
Description
ATX 24-Pin Power Connector
12V 8-pin Power Connector (Required)
COM Port 1 & COM 2 Header
Memory (DIMM) Slots (1 through 4)
System Fan Headers (Fans 1-5), Fan6: CPU Fan
Front Panel Control Header (*Note 2)
Floppy Disk Connector
IDE Primary Slot (Blue) (*Note 1)
Compact Flash Card (White) (*Note 1)
IPMI 2.0 Socket
Speaker Connector (Pins 3-4: Internal Buzzer Enable,
Pins 1-4: External Speaker Cable)
Chassis Intrusion Header
PWR LED
PS/2 Keyboard/Mouse Connector
Ethernet RJ45 (Gigabit LAN) Port1/Port2 Connectors
Parallel Port (Printer) Header
4 Intel SATA Headers
PCI 32-bit/66 MHz
PCI-X 133 MHz+PCI-Exp.x8 (Signal:x8 via Riser Cards)
Internal Buzzer
Back Panel Universal Serial Bus Ports 1,2
VGA Connector
Wake On LAN header
Wake On Ring header
Description (*(Refer to Addendum A)
Onboard Standby PWR warning LED Indicator
BIOS POST Code Indicators
1-5
Chapter 1: Introduction
Default Setting
See Section 2-7
(Open/Open: Disabled)
Open (Disabled)
Pins 1-2 (Enabled)
Open (Enabled)