Axle Components; Axle - Terex Genie TX-34/20 Service Manual

Augus 2022

Axle Components

8-1

Axle

How to Remove the Axle
ANSI/CSA/AS models:
1 Lower the outriggers and adjust to level the
machine and raise the wheels off the ground.
2 Disconnect the parking brake cable at the
parking brake handle.
3 Pull the cables free of the trailer.
4 Tag, disconnect and plug the brake line from the
back of the hub. Cap the fitting.
5 Clean up any brake fluid that may have spilled.
6 Repeat steps 4 through 5 for the other side.
7 Support and secure the axle assembly to an
appropriate lifting device.
8 Remove the axle mounting fasteners and
remove the axle from the machine.
Crushing hazard. The axle could
become unbalanced and fall if not
properly supported and secured
when removed from the machine.
Note: When the axle is installed, the brakes should
be bled. Refer to the appropriate brake
manufacturer's manual that was shipped with your
Genie TZ.
Part No. 825934
CE models:
1 Lower the outriggers and adjust to level the
machine and raise the wheels off the ground.
2 Disconnect the parking brake cable at the
tension equalizer.
3 Support and secure the axle assembly to an
appropriate lifting device.
4 Remove the axle mounting fasteners and
remove the axle from the machine.
Genie TZ-34/20
Section 4 • Repair Procedures
Crushing hazard. The axle could
become unbalanced and fall if not
properly supported and secured
when removed from the machine.
4 - 37