Automatic Power Shut-Off Function; Selecting The Menu Screen Position - Sharp DT300 Operation Manual

Using the "Options" Menu
Automatic Power Shut-
off Function
When no input signal is detected for more than
15 minutes, the projector will automatically en-
ter the standby mode if set to "
Select "Auto Power Off" in the "Options"
menu on the menu screen.
➝For operating the menu screen, see
pages 38 to 41.
Selected Item
Projector automatically enters the
standby mode after 15 minutes
without an input signal.
Automatic Power Shut-off disabled.
Note
• "Auto Power Off" is factory preset to "
• When the Auto Power Off function is set to
" (ON)", 5 minutes before the projector
enters the standby mode, the message "En-
ter STANDBY mode in X min." will appear on
the screen to indicate the remaining minutes.
Selecting the Menu
Screen Position
This function allows you to select the desired
position of the menu screen.
Select "Menu Position" in the "Options"
menu on the menu screen.
➝For operating the menu screen, see
pages 38 to 41.
Selected Item
Center The menu is displayed on the
center of the image.
Upper The menu is displayed on the
Right upper right of the image.
Lower The menu is displayed on the
Right lower right of the image.
Upper The menu is displayed on the
Left upper left of the image.
Lower The menu is displayed on the
Left lower left of the image.
-54 -54
DT-300_E_p51_56.p65
" (ON).
Description
".
Description
Page 54
On-screen Display
On-screen Display
03.10.29, 2:46 PM Adobe PageMaker 6.5J/PPC