Connecting To A Computer - Sharp DT300 Operation Manual

Connecting to a Computer

Connecting to a Computer
Using the DVI to 15-pin
D-sub Adaptor and the
RGB Cable (INPUT 2)
1
Connect a DVI to 15-pin D-sub
adaptor to the projector.
2
Connect the above adaptor to
an RGB cable.
3
Connect the above cable to the
computer.
• Secure the connectors by tightening the
thumbscrews.
Note
• Refer to "Computer Compatibility Chart" on
page 66 for a list of computer signals
compatible with the projector. Use with
computer signals other than those listed may
cause some of the functions not to work.
• When connecting the projector to a com-
puter in this way, select "RGB" for "Signal
Type" on the OSD menu or press
the remote control. (See page 52.)
• A Macintosh adaptor may be required for
use with some Macintosh computers.
Contact your nearest Sharp Authorized
Service Center or Dealer.
• Depending on the computer you are us-
ing, an image may not be projected unless
the signal output setting of the computer is
switched to the external output. Refer to
the computer operation manual for switch-
ing the computer signal output settings.
Connecting the thumbscrew cables
I Connect the thumbscrew cable making sure that it fits cor-
rectly into the terminal. Then, firmly secure the connec-
tors by tightening the screws on both sides of the plug.
I Do not remove the ferrite core attached to the RGB cable.
DT-300_E_p13_28.p65
on
Page 21
Optional
DVI to 15-pin D-sub adaptor
accessory
Type: AN-A1DV (7.9" (20 cm))
DVI to 15-pin D-sub adaptor
(sold separately)
RGB cable
(commercially available)
To RGB output terminal
Notebook computer
03.10.29, 2:40 PM
To INPUT 2 terminal
Ferrite core
-21
Adobe PageMaker 6.5J/PPC