Secure The Module To The Stud Framing; Install The Plumbing - Kohler K-1630 Installation Manual

Nail 1/4" (6 mm) thick furring strips
to shim out to the edge of the
nailing-in flange.
Drill small holes through the side
nailing-in flange 8" (20.3 cm) apart.
Use #6 large-head galvanized nails to secure
the side nailing-in flange to the studs.

3. Secure the Module to the Stud Framing

CAUTION: Risk of product damage. Do not lift the whirlpool by the piping or pump, or use the
piping or pump for structural support of the whirlpool.
With help, carefully lift the module into position.
Insert the drain tailpiece into the trap. Make sure the whirlpool is level and resting on all support
blocks.
Plumb and level the module along the nailing-in flanges, and use shims to level the module rim. Do
not support the module by the rim.
Place shims under the module body to add support when module is in use.
Drill small pilot holes 8" (20.3 cm) apart through the vertical nailing-in flanges along the front of the
module. Then drill small pilot holes through the horizontal nailing-in flange at each side and back
stud. Add shims between the nailing-in flange and the studs as needed to eliminate gaps.
Nail 1/4" (6 mm) thick furring strips to the studs to shim out to the edge of the nailing-in flange.
For metal stud construction, drill the fastener holes through the nailing-in flange and the metal
studs, and secure with sheet metal screws.
Use #6 large-head galvanized nails to secure the nailing-in flange to the studs.

4. Install the Plumbing

CAUTION: Risk of property damage. Ensure a watertight seal on the whirlpool drain.
Connect the drain to the trap according to the drain manufacturer's instructions.
NOTICE: An access panel will simplify future maintenance.
Install the faucet valving according to the faucet manufacturer's instructions. Do not install the
faucet trim until instructed. Open the hot and cold water supplies, and check the supply
connections for leakage.
Run water into the whirlpool, and check the drain connections for leakage.
1015417-2-C
Stud
Nailing-In Flange
Place shims under the whirlpool
body to provide support when the
whirlpool is in use.
6
Drill a small hole through the
back nailing-in flange at each
stud.
Kohler Co.