Table of Contents
Advertisement
Installation
Installation
The Touch Panels TP27 and TP37 are designed for vertical installation in the
location and
front panels of switching cabinets. Cut a mounting slot in the front panel in
conditions
preparation for installation of the Touch Panel. The thickness of the front panel
must not exceed 6 mm. No other holes need to be drilled for mounting.
Details regarding the mounting depth and mounting slot are provided in chap-
ter 14.
Degree of
The IP65 degree of protection for the front panel can only be ensured when the
protection
seal on the front plate of the Touch Panel is fitted correctly.
Caution
!
TP27, TP37 Equipment Manual
Release 01/00
The TP must be brought to room temperature before it is commissioned. If
condensation forms, do not switch on the TP until it absolutely dry.
To prevent the Touch Panel from overheating during operation,
– the angle of inclination specified in the technical data must not be
exceeded,
– do not expose the TP to direct sunlight
– ensure that the ventilation slits in the housing remain free after installa-
tion.
When the cabinet is opened, certain parts of the system that may conduct
hazardous voltage are exposed.
The TP was function–tested before shipping. If a fault occurs nevertheless,
please enclose a full account of the fault when returning the TP.
12
12-1
Advertisement
Table of Contents
