Table of Contents
Advertisement
Assembly Instructions
This section will explain how to assemble the DuoScreed.
NOTICE
It is recommended that you familiarize yourself with the
DuoScreed's components. For assistance identifying
components called out in the text, refer to Figure 2.
1. The DuoScreed is comprised of two major components.
The power unit (Honda GX35SAT gasoline engine) and
the strike-off blade. This DuoScreed is equipped with
a quick disconnect system, with which the power unit
can be mounted onto two aluminum clamping strips
with ease.
2. The aluminum clamping strip (retaining plate) is located
at the base of the power unit. This clamping strip is
what holds the blade in place with the aid of three quick
disconnect spring loaded wing nuts (Figure 4) that can
either be tighten or loosened by hand.
DSGPULW DUOSCREED • OPERATION MANUAL — REV. #8 (06/12/23) — PAGE 15
Figure 4. Blade Quick Disconnect System
ASSEMBLY INSTRUCTIONS
3. Determine whether you will be using the DuoScreed
on forms or as a wet screed. This will decide how the
power unit will be mounted. If the DuoScreed will be
used as a wet screed the wing nuts should be located
above the smooth edge of the blade. If the DuoScreed
will be used on forms (Figure 4) the wing nuts should
be located above the curled edge of the blade.
4. Loosen each of the three wing nuts about 1/4 inch (8
mm). It is not necessary to completely remove the wing
nuts from the aluminum clamping strip.
5. Locate the two red indicator arrows ) on the top of
the blade. The power unit should be placed squarely
between the two markers.
Advertisement
Table of Contents
