Table of Contents
Advertisement
1. Spark Plug – Provides spark to the ignition system.
Set spark plug gap to 0.024 - 0.028 inch (0.6 - 0.7 mm)
Clean spark plug once a week.
2. Muffler – Used to reduce noise and emissions. DO
NOT touch muffler while engine is running, let engine
cool before performing any maintenance.
3. Spark Arrester – Prevents sparks from leaving the
engine exhaust system, which could ignite flammable
materials.
4. Starter Grip – Grip this handle to start engine. See
engine starting section of this manual.
5. Recoil Starter (Pull Rope) – Type of engine starting
method.
6. Oil Filler Cap – Remove this cap to add engine oil.
Engine oil capacity is 0.11 quart (0.1 liters). Use SAE
10W-30.
PAGE 14 — DSGPULW DUOSCREED • OPERATION MANUAL — REV. #8 (06/12/23)
Figure 3. HONDA GX35SAT Components
ENGINE COMPONENTS
7. Fuel Tank – Holds approximately .172 gallons
(.65 liters) of unleaded gasoline.
8. Fuel Filler Cap – Remove this cap to add unleaded
gasoline to the fuel tank. Make sure cap is tighten
securely. DO NOT over fill.
9. Priming Bulb – Used in the starting of a cold engine
or an engine that has run out of fuel. Press the priming
bulb repeatedly until fuel can be seen inside the clear
plastic bulb.
10. Air Cleaner – Prevents dirt and other debris from
entering the fuel system. Release latch on side of air
filter compartment to gain access to filter element.
11. Choke Lever – Used in the starting of a cold engine,
or in cold weather conditions. The choke enriches the
fuel mixture for starting a cold engine.
Advertisement
Table of Contents
