Table of Contents
Advertisement
Operations
Control panel
The actual design of the control panel may differ with the model.
01 Cycle Selector
02 Display
03 Temp.
04 Rinse
05 Spin
36
English
Untitled-13 36
02
01
10
Turn the dial to select a cycle.
The display shows current cycle information and estimated time
remaining, or an information code when a problem occurs.
For buttons and icons, refer to the corresponding page.
Press to change the water temperature for the current cycle.
Press to change the rinse count for the current cycle. You can set
the rinse count to a max of 5, depending on the cycle.
Press to change the spinning speed for the current cycle. The
revolutions per minute (RPM) differs with the model.
• Rinse Hold: The final rinse process is suspended so that the
laundry remains in the water. To unload the laundry, run a
drain or spin process.
- To use the Rinse Hold option, press Spin repeatedly until the
Rinse Hold (
• No Spin: The drum does not rotate after the final drain process.
- To use the No Spin option, press Spin repeatedly until the No
Spin (
) indicator turns on.
• Spin Only: To run the Spin Only cycle, press Spin for 3 seconds.
When the cycle time and spinning speed appear, press Spin
repeatedly until a desired spinning speed is selected. Then,
press and hold Start/Pause (Hold to Start) to start the cycle. The
spinning time depends on the selected cycle.
06
02
03
04
) indicator turns on.
11
07
08
12
05
09
2019-06-17 PM 4:35:35
Advertisement
Table of Contents
