4-4.2 Advanced Chipset Control - Supermicro P4SCE User Manual

4-4.2 Advanced
Access the submenu to make changes to the following settings.
ECC Configuration
This setting allows you to enable or disable ECC (Error Correction and
Checking). The options are ECC and Non-ECC.
SATA Mode
This setting allows you to set the SATA Mode RAID via BIOS. The options
are RAID and IDE.
On-Chip Serial ATA
This setting allows you to configure On-Chip Chipset Configurations.
Select "Disabled" to disable SATA controller. If "Auto" is selected, BIOS
will automatically configure the settings for SATA controller. Select
"Combined Mode" to combine the functionality of Parallel ATA (PATA) and
Serial ATA(SATA) (* with the maximum of two IDE drives available for
each channel.) If "Enhanced Mode" is selected, both SATA and PATA
are supported (*with the maximum of 6 IDE drives available.) If "SATA
Only" is selected, SATA will operate in the Legacy Mode. The options
are Disabled, Auto, Combined Mode, Enhanced Mode, and SATA only.
Serial ATA Port0/1 mode
This setting allows you to configure
options are Primary Master , Primary Slave, Secondary Master,
Secondary Slave, SATA0 Master and SATA1 Master.
Chipset Control
4-7
Serial ATA Port0/1 modes
Chapter 4: BIOS
.The