Table of Contents
Advertisement
1. Enter the IP address of the product in a web browser and log into Web Config as an administrator.
2. Select the Device Management tab, then select Email Notification.
3. Set the contents of the email subject line by selecting items from the drop-down menus.
Note: You cannot select the same item in both menus. If the Location setting is longer than 32 bytes,
it will be truncated in the Subject line.
4. Enter up to five email addresses to receive the notification emails, and select the language of the
notification email.
5. In the Notification Settings area, select one or more email addresses to receive a notification for
each event.
6. Click OK to apply the settings.
Note: To clear the email notification settings, select Restore Default Settings. This clears all email
notification settings, not just the changes made in the current session.
Parent topic:
Related tasks
Accessing the Web Config Utility
Adjusting Power Saving Settings
The product can automatically enter sleep mode or turn off after it has not been used for a while. You
can set the delay before the product enters sleep mode or turns off.
1. Log in to the Web Config interface as an administrator.
2. Select the Device Management tab, then select the Power Saving setting.
3. Set Sleep Timer to the number of minutes before the product enters a low-power mode.
4. Select Power Off Timer to set the amount to time of inactivity before the product turns off.
Note: If you are using a printer with the fax feature enabled, select None.
Note: You can also configure the power saving settings using the control panel by selecting Settings >
General Settings > Basic Settings and selecting the feature you want to change.
Parent topic:
Configuring Product Settings
Configuring Product Settings
190
Advertisement
Table of Contents
