Table of Contents
Advertisement
8. Have a second person hold the console assem-
bly (E) near the handrail assembly (D).
Connect the wires (F) from the console assembly
(E) to the wires (G) from the handrail assembly
(D). The connectors should slide together
easily and snap into place with an audible
click. If they do not, turn one connector and
try again.
Do not pinch the wires (F, G) during this step.
Insert the wires into the handrail assembly (D) as
you set the console assembly (E) on the handrail
assembly. Make sure that the console assem-
bly is properly oriented so that the curved
edge (L) of the Console Pivot Bracket (138)
faces the front (M) of the handrail assembly.
Attach the console assembly (E) with two
M6 x 25mm Screws (8); do not fully tighten the
Screws yet.
9. Rotate the console assembly (E) so that it
faces the opposite direction. Tighten two
M6 x 25mm Screws (8) into the Console Pivot
Bracket (138); start both Screws, and then
firmly tighten them.
Next, identify the Left Pivot Cover (136). Attach
the Left Pivot Cover to the Console Pivot Bracket
(138) with an M4 x 20mm Screw (6); do not
overtighten the Screw.
8
138
F
D
9
E
12
E
8
L
M
G
6
136
8
138
Advertisement
Table of Contents
