Table of Contents
Advertisement
Warning
Danger of accidents Old brake fluid reduces the braking effect.
–
Make sure that brake fluid for the front and rear brake is changed in accordance with the service
schedule. (Your authorized Husqvarna Motorcycles workshop will be glad to help.)
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid corrodes paint.
Only use clean brake fluid from a sealed container.
K01107-10
F00405-11
F01126-10
–
Position the vehicle vertically.
–
1
Remove screw cap
with membrane
–
Manually press the brake caliper toward the brake disc to
push back the brake piston. Ensure that brake fluid does not
flow out of the brake fluid reservoir; extract some if neces-
sary.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake pis-
ton.
–
3
Remove cotter pins
, pull out pin
brake linings.
–
Clean the brake caliper and the brake caliper bracket.
–
5
Check that spring plate
6
pad sliding plate
in the brake caliper bracket are seated
correctly.
Info
The arrow on the spring plate points in the direction of
rotation of the brake disc.
BRAKE SYSTEM 12
2
and the O-ring.
4
, and remove the
in the brake caliper and brake
85
Advertisement
Table of Contents
