Nameplate And Decals - MULTIQUIP GLOBUG Series Operation And Parts Manual

3
DANGER
ELECTRICAL
SHOCK HAZARD
When replacing lamp and to prevent electrical
shock, ALWAYS shutdown the generator before
replacing lamp. Remember to let lamp cool before
removing. Use only recommended type lamp as
listed in parts manual.
DCL416
5
WARNING
To avoid injury,
you MUST read
and understand
operator's manual
15
before using this
machine.
This machine to
be operated by
qualified
personnel only.
Ask for training
as needed.
P/N 35137
PAGE 32 — GB114BS/BP GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #3 (01/06/09)
DANGER
To avoid accident or injury
NEVER exceed a travel
speed of 5 MPH when using
lighting system on a mobile
equipment.
DCL 1001
4
WARNING
BURN HAZARD
To prevent burns, NEVER
touch lamp while lamp is on.
Lamp surface gets extremely
hot! ALWAYS allow sufficient
time for lamp to cool down
6
before touching.
DCL417
WARNING
BURN HAZARD
To prevent burns, NEVER
touch ballast or cover while
lamp is on. These surfaces are
extremely hot! ALWAYS
sufficient time for both surfaces
to cool down before touching.
DANGER
ELECTRICAL
SHOCK HAZARD
NEVER touch a live power cord
or active electrical components
with wet hands or while standing
14 in water. The possibility of electrical
shock or even death! exists.
DCL410
LAMP
13
SWITCH
OFF ON
DCL424
12

NAMEPLATE AND DECALS

1
7
MODEL
SERIAL NO.
allow
DCL415
CAUTION
LAMP COVER BUZZER
Before operating GlowBug
ALWAYS unzip cover, fold into
bag on top of balloon and zip.
I f the cover has not been removed
a n audible alarm will sound when
power is applied to the GlowBug.
DCL404
DANGER
ELECTRICAL
SHOCK HAZARD
GROUND
GROUND To prevent electrical shock or
electrocution, the GlowBug
MUST be connected to an
earth ground.
(See NEC Article 250)
DCL427
S1123
2
DANGER
To avoid accident or
injury ALWAYS make
certain hardware is
securely fastened on
pipe clamps.
DCL1002
DANGER
To avoid accident or
injury ALWAYS make
certain hardware is
securely fastened on
pipe clamps.
DCL1002
2
8
CAUTION
LAMP INFORMATION
ALWAYS turn lamp OFF
first, before shutting down
generator.
Once lamp is turned OFF,
Allow lamp to cool down
before turning back on.
I t will take about 20 minutes
before lamp can be turned
back on.
DCL409
9
CAUTION
COVER
INFORMATION
Before operating GlowBug
ALWAYS unzip cover, fold into
bag on top of balloon and zip.
Bag Zipper
10
Cover
NEVER apply power to the
GlowBug until the cover has
been inserted inside the bag
11
and the balloon is fully exposed.
B e f o r e s t o r i n g G l o w B u g ,
ALWAYS fully cover balloon to
prevent damage from dust, dirt
and adverse weather conditions.
DCL413