Operation/Shutdown - MULTIQUIP GLOBUG Series Operation And Parts Manual

NOTICE
ALWAYS Make sure ballast is securely mounted to
a surface where it will not move, slip or fall. This will
prevent severe damage to the ballast.
3. Place the ON/OFF switch (Figure 12) on the ballast in
the ON position.
ON/OFF
SWITCH
ON
Figure 12. Ballast On/Off Switch (On Position)
4. Notice that the balloon envelope will begin to deploy
as soon as power is applied.
5. The lamp should now be on. If the lamp is not on,
check all connections and repeat steps 1 thru 4. If the
lamp still does not come on, contact Discount-
equipment.
6. The lighting system is now ready for use.
GB114BS/BP GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #3 (01/06/09) — PAGE 19
SHUTDOWN
1.
2.
3.
BALLAST

OPERATION/SHUTDOWN

Place the ON/OFF switch on the ballast to the OFF
position. The balloon should begin to defl ate and the
lamp turns off.
If using a portable generator, shut-down the generator
as referenced in the "Shutdown Section" of the supplied
generator manual. ALWAYS place the main circuit
breaker in the OFF position before turning off the
generator.
If using a power source other than an AC generator,
disconnect the ballast AC power cable from the power
source.