Labels - Epson FX-2190 Reference Manual

Note:
❏ Be sure your multipart forms do not exceed 0.46 mm (0.018 inch)
in thickness.
❏ Do not load paper that is curled or has been folded.

Labels

When printing on labels, use only the type of labels that are
mounted on continuous backing sheets with sprocket holes for
use with a tractor feeder. Do not try to print on single sheets with
labels because the printer may not feed labels on a shiny backing
sheet properly.
Thick paper, such as continuous paper with labels, requires a
straight or almost straight paper path. Load labels only in the front
(push tractor or pull tractor) or bottom (pull tractor) paper slot;
however, for best results, use the tractor in the pull position, and
load paper in the front or bottom paper slot.
The loading procedure for continuous paper with labels is the
same as that for ordinary continuous paper, except that you must
set the paper-thickness lever to 2 before printing. See "Loading
paper with the pull tractor" on page 35 for more information.
Paper Handling
2
2
2
2
2
2
2
2
2
2
2
2
55