Getting Started with AO Applications in Software
Note
For more information about programming analog output applications and triggers in
software, refer to the NI-DAQmx Help or the LabVIEW 8.x Help.
© National Instruments Corporation
Figure 3-12 shows the timing requirements for MasterTimebase.
Figure 3-12. MasterTimebase Timing Requirements
You can use the E Series device in the following analog output
applications:
•
Single-Point Generation
•
Finite Generation
•
Continuous Generation
•
Waveform Generation
You can perform these generations through DMA, interrupt, or
programmed I/O data transfer mechanisms. Some of the applications also
use start triggers and pause triggers.
t
p
t
t
w
w
t
= 50 ns minimum
p
t
= 23 ns minimum
w
3-15
Chapter 3
Analog Output
E Series User Manual