Table of Contents
Advertisement
Product Overview
Specifications.
Tractors
Height of Cut
Height Of Cut Range
Reel Bearings
Rollers
Bedknife
Bedknife Adjustment
Grass Shield
Counterweight
Net Weight
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
These cutting units will mount on the Greensmaster 3000, 3000-D, 3050, 3100, 3150,
3250-D, and 3150-Q Traction Units.
Cutting height is adjusted on the front roller by two vertical bolts and held by two locking bolts.
Standard bench height-of-cut range is 1.6 mm (0.062 inch) to 12.7 mm (0.500 inch). Bench
height-of-cut range with the High Height of Cut Kit installed is 7 mm (0.285 inch) to 25 mm
(1.00 inch). Effective height of cut may vary depending on turf conditions, type of bedknife,
rollers, and attachments installed
Two sealed stainless steel, deep groove ball bearings
The rear roller is a 5.1 cm (2 inch) diameter steel full roller
Replaceable single edged, high carbon steel bedknife is fastened to a machined cast iron
bedbar with 13 screws
Dual screw adjustment to the reel; detents corresponding to 0.018 mm (0.0007 inch)
bedknife movement for each indexed position
Non-adjustable shield with adjustable cut-off bar to improve grass discharge from reel in
wet conditions
A cast iron weight mounted opposite to the drive motor balances the cutting unit.
8 Blade—30 kg (65 lb), 11 Blade—31 kg (68 lb), 14 Blade—32 kg (71 lb)
9
Advertisement
Table of Contents
