Table Of Contents; Introduction - Toro 04618 Operator's Manual

Introduction

This cutting unit is designed for cutting turf on greens and
small fairways of golf courses.
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, or to register
your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers of
your product ready. Figure 1 identifies the location of the
model and serial numbers on the product. Write the numbers
in the space provided.
G020063
1. Location of the model and serial numbers
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol (Figure 2),
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
© 2014-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
Contents
Introduction .................................................................. 2
Safety ........................................................................... 3
Safety and Instructional Decals. ................................ 3
Setup ............................................................................ 4
Installing the Front Roller......................................... 4
Installing the Ball Studs ............................................ 4
Installing the Hoop Link, Offset Link, or Chain
Link ................................................................... 4
Propping Up the Cutting Unit .................................. 5
Repositioning the Counter Weights ............................ 5
Adjusting the Bedknife to the Reel ............................. 6
Adjusting the Rear Roller.......................................... 6
Adjusting the Height of Cut ...................................... 7
Adjusting the Cut-Off Bar ........................................ 8
Product Overview .......................................................... 9
Specifications. ........................................................ 9
Attachments/Accessories......................................... 9
Operation ....................................................................10
Cutting Unit Characteristics .....................................10
Daily Adjustments of the Cutting Unit.......................10
Maintenance .................................................................11
Servicing the Bedbar ...............................................11
Backlapping the Reel...............................................12
2
Figure 2
Contact us at www.Toro.com.
Printed in the USA.
All Rights Reserved