Table of Contents
Advertisement
Setup
Media and Additional Parts
Description
Ball stud
Operator's Manual
Parts catalog
Installing the Front Roller
The cutting unit is shipped without a front roller. Install the
roller using the loose parts supplied with the cutting unit and
installation instructions included with the roller.
Installing the Ball Studs
Install a ball stud on each end of the front roller (Figure 3).
G020075
1. Ball stud
Installing the Hoop Link, Offset
Link, or Chain Link
For cutting units that will be mounted on a traction unit with
a serial number prior to 240000001, the proper lift link must
be obtained and installed.
Note: The 2 bolts used to mount the lift link are shipped
installed on the cutting unit.
•
The Hoop Link (part number 105-5740) is required for
installation on the Greensmaster 3000, 3000-D, 3050,
3100, 3150, and 3150-Q traction units (they are supplied
with the traction unit).
Install the hoop link to the top of the cutting unit with
2 bolts. Torque the bolts to 34–40 N-m (25–30 ft-lb)
(Figure 4).
Figure 3
Qty.
2
Mount to roller
1
Read before installing and operating cutting unit
1
Use to reference part numbers
G020064
1. Hoop link
•
The Offset Link (part number 110-2397) is required for
installation on the Greensmaster 3250-D traction units
(they are supplied with the traction unit).
Install the offset link (Figure 5) to the top of the cutting
unit with 2 bolts. Torque the bolts to 34–40 N-m (25–30
ft-lb).
Important: Position the lift hook offset towards the
front of the cutting unit.
4
Use
Figure 4
Advertisement
Table of Contents
