11.15
Handlebar position
11.16
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
On the upper triple clamp, there are 2 holes at a distance of
each other.
Hole distance A
The holes on the handlebar support are placed at a distance of
from the center.
Hole distance B
The handlebar can be mounted in four different positions. This
allows the handlebar to be mounted in the most comfortable posi-
tion for the rider.
M00993-10
–
Remove screws
the handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Place the handlebar supports in the required position. Mount
and tighten screws
Guideline
Screw, handle-
bar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
M00993-11
Make sure the cables and wiring are positioned cor-
rectly.
TUNING THE CHASSIS 11
15 mm (0.59 in)
3.5 mm (0.138 in)
1
. Take off the handlebar clamps. Remove
2
. Take off the handlebar supports.
2
.
M10
40 Nm (29.5 lbf ft)
A
to
B
Loctite
®
243™
61