Checking The Rubber Grip - KTM 150 XC-W 2023 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.39
88
E01230-01

Checking the rubber grip

401197-01
E00889-10
Main work
–
Check the throttle cable routing.
Both throttle cables must be routed, side by side, on the
back of the handlebars, above the fuel tank bracket on the
right of the frame to the throttle valve body. Both throttle
cables must be secured behind the rubber strap of the fuel
tank support.
» If the throttle cable is not routed as specified:
–
Correct the throttle cable routing.
Finishing work
–
Install the fuel tank. (
–
Mount the seat. ( p. 73)
–
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve or
the throttle tube.
» If a rubber grip is damaged or worn:
–
Change the rubber grip.
–
1
Check that screw is firmly seated.
Guideline
Screw, fixed M4
grip
A
Diamond must be positioned visibly as shown in the fig-
ure.
p. 80)
5 Nm (3.7 lbf ft)
Loctite ® 243™