Steps
1. Align the screw hole on the LED board with the screw hole on the palm-rest assembly.
2. Replace the single screw (M2x3) to secure the LED board to the palm-rest assembly.
3. Route the LED-board cable and connect the cable to the connector on the system board.
CAUTION:
Do not route the LED-board cable under the coin-cell battery. Incorrect routing of the LED-board
cable may damage the LED board, LED-board cable, and system board.
4. Connect the touchpad cable to the connector on the system board.
Next steps
1. Install the
assembly inner
2. Install the battery.
3. Install the
hard
drive.
4. Install the
WWAN
card.
5. Install the
WLAN
card.
6. Install the
2280 solid-state drive
7. Install the
base
cover.
8. Install the
microSD
card.
9. Install the
SIM
card.
10. Follow the procedure in
Heat sink
Removing the heat sink and fan assembly - UMA configuration
Prerequisites
1. Follow the procedure in
frame.
or
2230 solid-state
After working inside your
Before working inside your
drive.
computer.
computer.
Removing and installing components
47