Installing The Palm-Rest Assembly - Dell Precision 3561 X2CND Service Manual

5. Remove the memory module.
6. Remove the 2280 solid-state drive
7. Remove the WLAN card.
8. Remove the WWAN card.
9. Remove the battery.
10. Remove the heat sink -
11. Remove the speakers
12. Remove the assembly inner
13. Remove the system board.
NOTE:
The system board can be removed with the heat sink attached in order to simplify the procedure and preserve the
thermal bond between the system board and heat sink.
14. Remove the power-button
15. Remove the LED board.
16. Remove the smart card
17. Remove the keyboard
18. Remove the display assembly.
About this task
The following image indicates the palm-rest assembly and provides a visual representation of the removal procedure.
Steps
After performing the steps in the pre-requisites, we are left with the palm-rest assembly.

Installing the palm-rest assembly

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the palm-rest assembly and provides a visual representation of the installation procedure.
or 2230 solid-state
UMA or discrete based on the system configuration.
frame.
board.
reader.
assembly.
drive.
Removing and installing components 93