Table of Contents
Advertisement
Steps
1. Place the display assembly on the system. Align the screw holes on the display hinges with screw holes on the palm-rest
assembly.
2. Replace the six (M2.5x5) screws that secure the display hinges to the palm-rest assembly.
3. Close the display.
4. Route the display and eDP cable through the routing guide on the system board.
5. Connect the eDP cable to the connector on the system board.
6. Connect the display cable to the connector on the system board.
7. Adhere the tape that secures the display cable to the system board.
8. Connect the IR camera cable from its connector on the system board (for models shipped with an IR camera).
9. Connect the touchscreen cable from its connector on the system board (for models shipped with a touchscreen).
10. Align the screw holes on the eDP cable bracket with the screw holes on the system board.
11. Replace the two screws (M2x3) that secure the eDP cable bracket to the system board.
12. Route the WLAN and WWAN antenna cables through the routing guide and adhere the tape to secure the cables to the
system board.
Next steps
1. Install the
WWAN
card.
2. Install the
WLAN
card.
3. Install the
base
cover.
4. Install the
microSD
card.
5. Install the
SIM
card.
6. Follow the procedure in
Display bezel
Removing the display bezel
Prerequisites
1. Follow the procedure in
2. Remove the
SIM
card.
3. Remove the
microSD
4. Remove the
base
cover.
5. Remove the
WLAN
card.
6. Remove the
WWAN
card.
7. Remove the
display
assembly.
After working inside your
Before working inside your
card.
computer.
computer.
Removing and installing components
75
Advertisement
Table of Contents
