Table of Contents
Advertisement
POI Flight Plan
Close FreeFlight 6 USA, to get to your flying spot, to prepare ANAFI USA and your
Skycontroller USA for the flight.
Tap the PILOTING MODE box on the HUD to call the options. Select Flight Plan: the previous
plan you set up appears.
Tap the green arrow on the right of the left bottom bar of the Flight Plan interface to begin
the Flight Plan. ANAFI USA takes off, flies to the first waypoint and starts the Flight Plan. At
the end of the Flight Plan, depending on your settings and depending on your version of
FreeFlight 6 USA, ANAFI USA lands at, or hovers over, the last waypoint you have set.
In this example, ANAFI USA's final waypoint is also its landing spot.
Warning: Activate and monitor every Flight Plan with extreme care: always verify your
drone's route is safe, and clear of obstacles. Always maintain visual contact with
ANAFI USA, and always be ready to stop the Flight Plan (tap the STOP box of your HUD or
reclaim commands of the drone) in case of danger or unexpected obstacles.
Touch & Fly: Waypoint
Waypoint is the default Touch & Fly mode. It enables you to fly ANAFI USA to any point on
the map. Tap Touch & Fly from the PILOTING MODE box menu. The map of your
surroundings opens full screen. The live image captured by ANAFI USA is minimized in the
bottom right corner of your screen.
Tap a point on the map to select a destination for ANAFI USA. This point is marked as a
white circle with a green border. For each new Waypoint Touch & Fly session, FreeFlight 6
USA asks you to confirm the first destination of ANAFI USA as on the following screen
capture. Tap the green TAP HERE TO START box, ANAFI USA flies toward its designated
destination. Use the slider on the right of the screen to control the drone's altitude (the
green figure inside the circle) when it reaches its destination.
105
Advertisement
Table of Contents
