Touch & Fly: Waypoint; Touch & Fly: Poi - Parrot ANAFI USA User Manual

Touch & Fly: Waypoint
Waypoint is the default "Touch & Fly" mode. It enables you to fly
point on the map. Tap "Touch & Fly" from the "PILOTING MODE" box menu. The map of
your surroundings opens full screen. The live image captured by
minimized in the bottom right corner of your screen.
Tap a point on the map to select a destination for
a white circle with a green border. For each new Waypoint Touch & Fly session,
FreeFlight 6 asks you to confirm the first destination of
following screen capture. Tap the green "TAP HERE TO START" box,
toward its designated destination. Use the slider on the right of the screen to control
the drone's altitude (the green figure inside the circle) when it reaches its destination.
Activate "Touch & Fly" Waypoint with care: be especially careful with your touches on the
screen in this mode, as after the initial confirmation, any tap on the map will immediately
send
For this reason, Parrot recommends you set your FreeFlight 6 filming or photography
options before activating the "Touch & Fly" Waypoint mode. If, by mistake, you have sent
toward a dangerous area, tap the STOP box at the center of the top bar of
the HUD, or firmly reclaim commands from the Parrot Skycontroller 3.
Touch & Fly: POI
To access the POI Touch & Fly option, tap the "Type" box from the lower bar of the
HUD, and select POI.
In POI mode, tap a point on the map to create a point of interest (POI), marked as a
white square diamond with a blue border, labelled with a POI icon. Control the height
of the POI (the blue figure inside the square diamond) through the slider on the right:
this effectively controls the tilt of the gimbal, while you use the Parrot Skycontroller 3
to fly around your target.
published on September 17, 2020
User Guide v6.7 –
Android Touch & Fly Waypoint: first destination confirmation screen
to the corresponding spot.
remains focused on the POI.
to any
is
: this point is marked as
as on the
flies
81