Planning - Craftsman 139.5391 Owner's Manual

Planning (Continued)
ONE-PIECE DOOR INSTALLATIONS
• Generally, a one-piece door does not require
reinforcement. If your door is lightweight, refer to
the information relating to sectional doors in
Installation Step 11.
• Depending on your door's construction, you may
need additional mounting hardware for the door
bracket (Step 11).
Without a properly working safety reversal system,
persons (particularly small children) could be
SERIOUSLYINJUREDor KILLED by a closing garage
door.
• The gap between the bottom of the garage door and
the floor MUST NOTexceed 1/4" (6 ram). Otherwise,
the safety reversal system may not work properly.
• The floor or the garage door MUST be repaired to
eliminate the gap.
ONE-PIECE DOOR WITHOUT TRACK
FINISHED CEILING
Support bracket
& fastening
hardware is required.
See page 16.
Safety Reversing Sensor
Rail
Slack in chain tension
is normal when garage
door is closed
Wail-mounted
Door Control
Safety Reversing
Gap between floor Sensor
and bottom of door must not exceed 1/4" (6 rnm).
Motor Unit
Trolley Stop Bolt
eader
/atl
CLOSED POSITION
cable Trolley
Emergency
Release
Rope & Handle
ONE-PIECE DOOR WITH TRACK
Safety
Reversing Sensor
Access I
Door I
()1
Revel*sing
Gap between floor Sensor
and bottom of door
must not exceed 1/4" (6 mm).
CLOSED POSITION
Trolley Stop Bolt Cable
Header Cu_'ed
Bracket Door Ar
_D °°°°°°°©°
Door I
Bracket Straight
Door
Garage Arm
oct
Chain
Rail
Eme_ency
Release
Rope &
Handle
5