Install Chain/Cable & Attach The Sprocket Cover - Craftsman 139.53962 SRT Owner's Manual

Assembly Step 4
Install the Chain/Cable
and Attach the Sprocket Cover
1. Pull the cable around the idler pulley and toward
the trolley.
2. Connect the cable loop to the retaining slot on
the trolley, as shown:
• From below, push pins of master link bar up
through cable loop and trolley slot.
• Push master link cap over pins and past pin
notches.
• Slide clip-on spring over cap and onto pin
notches until both pins are securely locked in
place.
3. With the trolley against the pliers, dispense the
remainder of the cable/chain along the rail toward
the powerhead and around the sprocket. The
sprocket teeth must engage the chain.
4. Check to make sure the chain is not twisted, then
connect it to the threaded shaft with the
remaining master!ink..
5. Thread the inner nut and lock washer onto the
the trolley shaft.
6. Insert the trolley threaded shaft through the hole
in the trolley. Be sure the chain is not twisted.
7. Loosely thread the outer nut onto the trolley
shaft.
8. Remove the locking pliers.
9. Align the tabs on the sprocket cover with the slots
in the mounting plate. Squeeze cover and insert
tabs in slots.
Idler
Pulley
DispensingCarton
Leave Chain and Cable
inside Dispensing
Carton to Prevent Kinking.
Keep Chain and Cable
Taut When Dispensing
i
I i
i
Master Link _ Master
Clip-On Spr_ng _ Link Cap
i
Trolley Pin
Threaded Notch
Shaft
Master
Link Bar
Round
;lotted Hole
' ' Hole
i i
' Sprocket Opener
Cable Cover ; ' Sprocket
Front Back
I q
i
Master Link
Master
Clip-On Spring _ _ Link Cap
Cable
Loop
\
Mounting
Plate
10