Orientation - Carrier 58TP0B Installation, Start-Up, Operating And Service And Maintenance Instructions

58TP0B/58TP1B: Installation, Start-up, Operating and Service and Maintenance Instructions
Sidewall Venting
This furnace is not approved for direct sidewall horizontal venting.
Per section 12.4.3 of the NFPA 54/ANSI Z223.1, any listed mechanical
venter may be used, when approved by the authority having jurisdiction.
Caution!! For the following applications, use the minimum vertical heights as specified below.
FURNACE

ORIENTATION

Downflow Vent elbow up then left -
Downflow Vent elbow left, then up -
Downflow Vent elbow up, then right -
Horizontal Left Vent elbow right, then up -
Horizontal Left
*. 4-in. (102 mm) inside casing or vent guard
†. Including 4 in. (102 mm) vent section(s)
NOTE: All vent configurations must also meet National Fuel Gas Code venting requirements NFPA 54/ANSI Z223.
Fig. 32 – Upflow Application - Vent Elbow Up
Fig. 33 – Upflow Application - Vent Elbow Right
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
For all other applications, follow exclusively the National Fuel Gas Code.
Table 9 – Recommended Minimum Vent Height Per Furnace and Vent Orientation
VENT ORIENTATION
Fig. 35
Fig. 38
Fig. 39
Fig. 40
Vent Elbow up - Fig. 41
Select the listed mechanical venter to match the BTUh input of the
furnace being vented.
requirements for venting and termination included with the listed
mechanical venter.
FURNACE INPUT
(BTUH/HR)
110,000
110,000
132,000
110,000
132,000
132,000
Fig. 34 – Horizontal Left Application - Vent Elbow Left
A03208
Fig. 35 – Downflow Application - Vent Elbow Up then Left
A03209
23
Follow all manufacturer's
MIN. VENT MIN. VERTICAL VENT
DIAMETER HEIGHT
*
IN. (mm) FT. (M)
5 (127) 10 (3.0)
5 (127) 12 (3.6)
5 (127) 10 (3.0)
5 (127) 7 (2.1)
5 (127) 7 (2.1)
installation
†
A03213
A03210