Carrier 58TP0B Installation, Start-Up, Operating And Service And Maintenance Instructions page 25

58TP0B/58TP1B: Installation, Start-up, Operating and Service and Maintenance Instructions
Fig. 43 – Horizontal Right Application - Vent Elbow Left then Up
Fig. 44 – Horizontal Right Application-Vent Elbow Left
Notes for Venting
1. For common vent, vent connector sizing and vent material: United
States-use the NFPA 54/ANSI Z223.
2. Immediately increase to 5-in. (102 mm) or 6-in. (152 mm) vent
connector outside furnace casing when 5-in. (127 mm) vent
connector is required, refer to Note 1 above.
3. Side outlet vent for upflow and downflow installations must use
Type B vent immediately after exiting the furnace, except when
factory-approved Downflow Vent Guard Kit is used in the
downflow position. See Product Data Sheet for accessory listing.
4. Type-B vent where required, refer to Note 1 above.
5. A 4-in.(102 mm) single-wall (26 ga. min.) vent must be used inside
furnace casing and when the factory-approved Downflow Vent
Guard Kit is used external to the furnace. See Product Data Sheet
for accessory listing.
6. Accessory Downflow Vent Guard Kit required in downflow
installations with lower vent configuration. See Product Data Sheet
for accessory listing.
7. Chimney Adapter Kit may be required for exterior masonry
chimney applications. Refer to Chimney Adapter Kit for sizing and
complete application details. See Product Data Sheet for accessory
listing.
8. Secure vent connector to furnace elbow with (2) corrosion-resistant
sheet metal screws, spaced approximately 180_ apart.
9. Secure all other single wall vent connector joints with (3) corrosion
resistant screws spaced approximately 120_ apart. Secure Type-B
vent connectors per
recommendations.
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
vent connector manufacturer's
A03219
A02068
25