Craftsman 137.218073 Operator's Manual page 40

ADJUSTING THE REAR OUTFEED
SUPPORT (FIG. RR)
1. The rear outfeed support (1) should
be positioned as close as possible
to the rear of the table when ripping
short material.
2. The rear outfeed support (1) should
be fully extended when ripping
longer materials that require
extra support.
Fig. RR
ADJUSTING CAM LOCKING LEVER
(FIG. SS)
If the extension table moves when
it is open and locked, then the cam
locking lever (1) may be loose and need
adjustment. To adjust the locking lever
tension, turn the nut (2) with an 8 mm
wrench until it is tightened, but do not
over tighten.
Fig. SS
Under Table View
1
1
2
40 40