Craftsman 137.218073 Operator's Manual page 22

ASSEMBLING TABLE SAW TO
STAND USING LOCK LEVER (FIG. G)
1. Attach the locking lever assembly (18)
to the top of the leg (2).
2. Lift up the locking lever (19).
3. Thread the two screws (20) into the
holes (21) of the locking bracket (24)
and stand.
NOTE: You may need to loosen the
two short support brackets if the
two mounting holes are not lined up
correctly. Retighten these bolts once
you have added the lever locks.
4. Attach the lock nuts (22) and tighten
with an 8 mm or adjustable wrench.
5. Install the other locking lever
assemblies in exactly the
same manner.
6. Position the saw base on the stand.
7. Line up the lever lock cover (23) to
the saw base and push down the
locking lever (19).
8. Fasten saw to stand using four
locking lever assemblies (18).
NOTE: The four locking lever
assemblies (18) are provided for
quick releasing the table saw from
the stand.
WARNING
!
All four levers must be locked in the
down position before operating saw.
Fig. G
18
20
21
24
19
23
22
2
MOUNTING BASE TO STAND USING
BOLTS (FIG. H)
You can also attach the saw base to the
stand using standard bolts.
1. Fasten the base to the stand using
the four long bolts (25), flat
washers (26), and nuts (27).
2. Place a washer on the bolt and insert
thru the hole in saw base and slot
in stand. Attach the nut and tighten
using a 13 mm wrench. Repeat for
other three corners.
Fig. H
25
26
27
SAW MOUNTED TO WORK
SURFACE (FIG. I)
1. If the leg set will not be used, the
saw must be properly secured to
a sturdy workbench using the four
mounting holes at the base of
the saw.
2. The surface of the table where the
saw is to be mounted must have
a hole large enough to facilitate
sawdust fall-through and removal.
22 22
25
26
27