Table of Contents
Advertisement
5.
When you use RadiCS / RadiCS LE or connect a USB device (peripheral device
that supports USB) to the monitor, connect the USB cable between the USB
downstream port of the PC and the USB upstream port of the monitor.
2-3. Turning On the Power
1.
Touch
to turn on the power to the monitor.
The power switch indicator of the monitor lights up green.
If the indicator does not light up, see "Chapter 3 No-Picture Problem" (page 19).
Note
• To find the location of the power switch when the monitor power is shut off, touch any of the buttons besides
to make the
2.
Turn on the PC.
The screen image appears.
If an image does not appear, refer to "Chapter 3 No-Picture Problem" (page 19) for additional advice.
Attention
• For maximum power saving, it is recommended that the Power button be turned off. When not using the
monitor, you can turn off the main power supply or disconnect the power plug so that the power is cut
completely.
Note
• In order to maximize the monitor's lifespan by impeding brightness degradation and to reduce power
consumption, carry out the following:
- Use the power saving function of the PC or monitor.
- Turn off the monitor after using it.
USB cable: UU300
indicator flash.
Chapter 2 Installation / Connection
17
Advertisement
Table of Contents
