Turning On The Power - Eizo RadiForce MX317W Instructions For Use Manual

Hide thumbs Also See for RadiForce MX317W:
Table of Contents

Advertisement

2 | Installation / Connection
3. When you are not using a USB-C connection and when you use RadiCS / RadiCS LE or
connect a USB device (peripheral device that supports USB) to the monitor, connect the
USB 2.0 cable to the USB-B connector on the monitor and the USB-A connector on the
PC.
When you are using a USB-C connection and when you use RadiCS / RadiCS LE or
when you connect a USB device (USB-connected peripheral device) to the monitor, set
"USB Selection" in the setting menu to "USB-C" (see "USB Selection" in the Installation
Manual).
Attention
• When connecting the monitor to a PC on which RadiCS / RadiCS LE has been installed, connect
to USB-B 1 (
• When using USB-B 2 (
setting in the Setting Menu (see "USB Selection" in the Installation Manual).

2.3 Turning On the Power

1. Touch
to turn on the power to the monitor.
The power switch indicator of the monitor lights up green.
If the indicator does not light up, see
Note
• When you touch any of the operation switches excluding
starts flashing to let you know where the power switch is located.
2. Turn on the PC.
The screen image appears.
If an image does not appear, see
Attention
• When connecting for the first time or changing the connection method, display settings such as
resolution and display scale may not be appropriate. Check if the settings for the PC are properly
configured.
• For power saving purposes, it is recommended that the Power button be turned off. When not
using the monitor, you can turn off the main power supply or disconnect the power plug so that
the power is cut completely.
Note
• In order to maximize the monitor's lifespan by impeding brightness degradation and to reduce
power consumption, carry out the following:
– Use the power saving function of the PC or monitor.
– Turn off the monitor after using it.
28
USB 2.0 cable: UU300
) or USB-C (upstream:
), remove the cap in advance. In addition, change the "USB selection"
3 No-Picture Problem [} 30]
).
3 No-Picture Problem
with the monitor power turned off,
[} 30].
for additional advice.

Advertisement

Table of Contents
loading

Table of Contents